Avaya callpilot 1002rp Hardware Installation page 56

Installing the server and connecting the peripheral devices
Note:
For details on the DC power source for 1002rp DC servers, see
supply module (AC or DC)
To connect the 1002rp AC server to power
1.
2. Plug the other end into a wall receptacle or power bar.
®
56 Avaya CallPilot 1002rp Server Hardware Installation
on page 34
Warning:
Risk of personal injury, risk of hardware failure
The power outlets used by the CallPilot server and its peripheral devices must
be connected to the same single-point ground reference as the one used by the
switch with MGate cards (NTRB18CA) connected to the CallPilot server. If this
requirement is not met, power transients can cause personal injury, or hardware
failure, or both. Refer to the Installation and Configuration Task List
(NN44200-306) for more information on single-point grounding requirements.
Plug the server AC power cord into the server rear panel.
Installing the second power
December 2010