Table of Contents
Advertisement
To connect the mouse, keyboard, and monitor to the server
1. Place the monitor, keyboard, and mouse in the same location as the server.
2. Plug the keyboard/mouse dual cable into the PS/2 connector on the SBC card
3. Plug the keyboard and mouse into the appropriate connectors on the keyboard/
4. Plug the monitor into the monitor connector on the SBC card. Tighten the screws
5. Ensure that a single-point ground reference is available for all the power outlets
6. Connect the power cord to the monitor and plug the other end into a wall receptacle
7. Turn on the monitor.
To connect the modem to the server
1. Ensure that the modem AC power cord is not plugged in.
2. Connect the large 25-pin male connector to the back of the modem. Tighten the
3. Connect the 9-pin female connector to COM1 at the rear of the server. Tighten the
4. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
5. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
6. Ensure that a single-point ground reference is available for all the power outlets
7. Connect the power cord to the modem, and plug the other end into a wall receptacle
8. Turn on the modem.
®
Avaya CallPilot
1002rp Server Hardware Installation
faceplate (see the diagram above).
mouse dual cable.
on the connector.
serving the CallPilot server and its peripherals. Before the CallPilot server
installation, a qualified electrician must implement the single-point ground reference
requirement between the power outlets of the CallPilot server and the power outlets
of the switch.
or power bar.
Note:
Ensure that the power source is consistent with the SBC for all ancillary
equipment.
connector screws.
connector screws.
serving the CallPilot server and its peripherals. Before the CallPilot server
installation, a qualified electrician must implement the single-point ground reference
requirement between the power outlets of the CallPilot server and the power outlets
of the switch.
or power bar.
Note:
Ensure that the power source is consistent with the SBC for all ancillary
equipment.
Rear panel connectors
December 2010
49
Advertisement
Table of Contents
