Table of Contents
Advertisement
Preparing for installation
To remove the server cover
1.
2. Loosen the three thumbscrews at the rear of the top cover.
3. Remove the server cover by pulling the cover toward the rear of the chassis, and
4. Clip the lead from your ESD wrist strap to an unpainted metal section of the chassis.
®
30
Avaya CallPilot
1002rp Server Hardware Installation
Voltage:
Risk of electric shock
High current inside the chassis can cause severe injury.
Caution:
Risk of equipment damage
Take precautions to protect internal components. Electrostatic discharge (ESD)
can render boards damaged or unusable. Wear an ESD wrist strap.
Remove the front bezel (see
then lifting it up and off.
To remove the front bezel
on page 29).
December 2010
Advertisement
Table of Contents
