Using Your Shower - Mira Elite ST Installation Manual

Using Your Shower

Read the section 'Important Safety Information' first.
Note! Rapid/Excessive movement of the flow and/or temperature control levers
may result in momentary unstable blend temperatures.
1.
Switch on electrical supply.
3.
Set to desired position.
5.
Allow 10-15 seconds for any temperature adjustments to reach the handset.
Care is required when adjusting flow or temperature, make sure that the
temperature has stabilised.
6.
Press STOP button. Shower will
continue to run for a few seconds
before stopping.
Power
2.
Press START button.
4.
Check water temperature before
entering shower.
7.
A small amount of water may
continue to drain over a few
minutes.
18
+
_
+
_