Installation - Mira Elite ST Installation Manual

Read the section 'Important Safety Information' first.
1.
Electrical supply is turned
off at the mains.
4.
Remove the cover and
determine supply pipe
position.
7.
Hold the product on the
wall in the desired location
and mark the positions of
the fixing holes.
Remove the product from
the wall.
Drill the three holes.
(Wall fixings are not supplied.
For solid wall structures a red
rawl plug and a no. 8 x 1½"
countersunk brass or stainless
steel screw should be used.
For other wall structures such
as panels alternative fixings
may be required. A minimum
of 3 fixing screws should be
used)

INSTALLATION

2.
200 mm
200 mm minimum gap
from ceiling.
5.
For rear inlet, use soldered
elbow. Do not trap green
wire.
8.
Fit Rubber Feet and fix
appliance to wall.
13
3.
Remove the four cover
screws.
6.
CAUTION! Do not drill into
buried cables or pipes.
9.
Flush a minimum of 10
litres through pipework.