Components and Mounting Diagram
Typical Installation
Mounting Instructions
1. Attach and secure the desired mounting bracket to the highest point on the safety cage, following these precautions:
The plate must be mounted so the antenna is not damaged while the vehicle or any of its parts are
l
moving.
The antenna mounting portion of the bracket must be parallel to the floor.
l
If the Thor VM2 requires two antennas, they must be mounted at least 12 inches (304.8mm) apart.
l
2. Attach the female connector of the coaxial cable to the antenna connector on the vehicle mounted Thor VM2.
3. Secure the whip antenna to the mounting bracket.
1. Nut
2. Washer
3. Washer
4. Base Plate Bracket
5. To Antenna
6. To Thor VM2 Antenna Connector
7. Antenna
8. Right Angle Bracket (not shown)
1. Antenna
2. Mounting Bracket (802.11
kit only)
3. Vehicle Safety Cage
4. Cable
5. Vehicle Mounted Thor VM2
4-19