Registering A Network Password; Specifying Standby Power Consumption - Canon WUX6000 User Manual

Registering a Network
Password
> [Network settings] >
network password]
Register the projector network
password.
When [Register network password] is
selected, the window shown below
appears.
Enter a 4-digit password.
Enter the password using the [ ] / [ ] /
[ ] / [ ] buttons on the remote control.
Press the OK button to accept your
setting and then press the MENU
button.
• If you forget the password, press [ ] [OK]
[ ] [OK] [ ] [OK] to restore the factory
default setting.
• The factory default is [ ] [ ] [ ] [ ].
Downloaded From projector-manual.com Canon Manuals
Specifying Standby
Power Consumption
[Register
Specify network function operating
status in standby mode as follows.
Normal All network functions are available
Low-
power
Press the OK button to accept your
setting and then press the MENU
button.
• [Low-power] is the factory default.
• [Low-power] may delay access over the
• Power consumption when [Network function
167
Completing Projector Settings
> [Network settings] >
standby settings]
even in standby mode, including
the web screen, control over the
network, and PJLink.
All network functions are available
even in standby mode.
However, the projector may be
less responsive than usual when
some functions are initially used.
network for some functions. For faster
access, select [Normal].
(wired)] is [On] varies depending on
whether [Network standby settings] is set to
[Normal] or [Low-power].
[Network