Table of Contents
Advertisement
Advanced
Power management
To reduce power consumption and maintain life cycle of
light source, the power management function will turn off
the projection light source if your projector has no signals
for a period of time.
1) Press
button to select [Power management]
menu.
2) Press <OK > button.
3) Press
button to switch required item.
Ready..........The POWER light indicator flashes
green when the light source is fully
cooled down. The light source turns on
again if an input signal is connected or
any key (except the
on the rear panel and remote
controller is pressed during this period
of time.
Shut down....The projector shut down after the
light source is fully cooled down.
Disable.........Disable the power management
function.
Timer............Once the input signal is interrupted
and no keys has been pressed for 30
seconds afterwards, the "No signal"
message displays in the timer. The
timer counts down until the light source
turns off. Press arrow key to set up the
timer in range of 1~30 minutes.
Ready Countdown...● Set up the interval from
Note:
● Factory default for standby time: 5 minutes. Count down for ready mode: 5 minutes.
power button )
ready mode change to
standby (0 to 30 minutes). A
setting of zero minute keeps
your projector from auto
transition.
● Press the Power key to
change your projector from
ready to standby mode and
any other key to power it on.
Power management menu
Advanced
Ready
Shut down
Disable
Timer
Ready countdown
Power management
64
Power management
No signal
0 1
:
2 0
Remaining time before
poweroff the light source.
5 Min
5 Min
Advertisement
Table of Contents
