Safety Instruction And Laser Safety Information - Stairville ColorStar 500 RGB Owner's Manual

Thanks a lot for purchasing our Dj Lase ColorStar 500. Please read this user
manual carefully and follow the instructions to avoid danger or damage to the
unit due to mishandling. Keep this user guide for future reference. If you give
the unit to another user, be sure that he also receives this instruction booklet.
Safety instruction and
Laser safety information
You have to carefully read the instructions, which include important
information about the installation, usage and maintenance, BEFORE
operating this device.
Unpack and check carefully there is no transportation damage before
X
using the unit. Never operate a damaged unit!
Before operating, ensure that the voltage and frequency of power supply
X
match the power requirements of the unit as stated in this manual.
The unit is for indoor use only. Use it only in a dry location. Exposing the
X
device to rain or moisture would cause the risk of electrical shock or fire.
The unit must be installed in a location with adequate ventilation, at least
X
50 cm from adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect the device from the mains power before any servicing or
X
maintenance. Replace the fuse only with the same type. Do not use any
other type of fuse.
Never sever or manipulate the power cord or the plug. If a power cord is
X
provided with an earth lead, this is mandatory to ensure safe operation!
Otherwise a LIFE THREATENING situation exists!
Notice regarding power disconnection:
X
To disconnect the device from the power source the power plug must
be removed from the power socket. For this reason the device must
be placed in a position where a constant unobstructed access to the
power socket is assured, thus in an emergency situation you are able
to immediately pull out the power plug. To eliminate the risk of fire you
must completely disconnect the power plug from the power socket after
the device has been used.
Always grasp the power cord by the plug. Do not pull on the cord itself
X
and never touch the power cord with wet hands as this could result in
a short circuit or an electrical shock. Do not place the device, speaker
cabinets or anything else on the power cord and make sure that it does
not become clamped. Place the power cord in a position where it can
not be trod on. A damaged power cord can cause a fire or an electrical
www.thomann.de
3