Canon LBP352 User Manual page 502

Syntax error.
Invalid data has been sent during printing with the UFR II printer driver.
● Change the printer driver settings or the format of print data, and print the file again.
● When you press
Toner cartridge will soon reach end of lifetime.
The replacement time for the toner cartridge is near.
● Make sure that you have a replacement toner cartridge ready.
● Replace the toner cartridge if you see this message before you start to print a large job.
Replacing Toner Cartridges(P. 521)
● You can press
Turn OFF main power. Check options.
The duplex unit or an optional accessory
● Shut down the machine, properly install the duplex unit or optional accessory, and then turn ON the
power.
Turning ON/OFF the Power(P. 33)
The duplex unit or an optional accessory
● Shut down the machine, properly install the duplex unit or optional accessory, and then turn ON the
power.
Turning ON/OFF the Power(P. 33)
The connection part of the duplex unit or an optional accessory
● Shut down the machine, unplug the power plug from the AC power outlet, and then contact your local
authorized Canon dealer.
Turning OFF the Power (Performing a Shutdown)(P. 33)
*
Paper Feeder, Paper Deck, Envelope Feeder
XPS document data error.
XPS data is damaged.
● Check that XPS data is not damaged and that the XPS data format is supported by the machine, and then
try printing the document again.
A large file has been sent by Direct Print.
● Optimize the XPS file to reduce its size or retry printing after dividing the file.
● Install the SD card, and then resend the data to the machine.
Installing an SD Card(P. 583)
● Send the data from the USB memory device to the machine.
Printing from USB Memory (USB Direct Print)(P. 120)
Troubleshooting
( ), the print job is canceled.
( ) to continue printing.
* is not properly installed.
* has been detached when the machine is ON.
495
* has a contact failure.