Canon LBP352 User Manual page 499

Performing a Hard Reset(P. 451)
● You can press
Not enough memory for PDF processing.
Memory for processing the PDF file is insufficient.
● Optimize the PDF file to reduce its size or retry printing after dividing the file.
● If you tried USB Direct Print or Direct Print, printing may be properly performed when it is restarted
from the printer driver.
● To remove the error message, perform a soft reset to cancel the print job.
Not enough memory for XPS processing.
Memory for XPS processing is insufficient.
● When the XPS file contains a ProgressiveJpeg image or the like, convert the image to a TIFF or
BaselineJPEG format, and print the file again.
● You can press
guaranteed.
Not enough spool memory.
Printing an excessive amount of data has been attempted.
● Specify the reduced paper size, and print the file again.
● Set <Image Refinement> to <Off>, and print the file again.
Image Refinement(P. 400)
● Set <2-Sided Printing> to <Off>, and print the file again.
2-Sided Printing(P. 459)
● Change the <Halftones> setting, and print the file again.
Halftones(P. 400)
● You can press
Not enough system memory.
Memory for data processing (mainly, graphics and characters) in the system is insufficient.
● Perform a hard reset, and print the file again.
Performing a Hard Reset(P. 451)
● You can press
cannot be printed properly.
Not enough work memory.
Memory dedicated to each print mode is insufficient.
● Perform a hard reset, and print the file again.
Performing a Hard Reset(P. 451)
Troubleshooting
( ) to continue printing. However, the data that overflowed is not registered.
( ) to continue printing. However, the output result of pages with errors is not
( ) to continue printing. However, pages with errors are not printed.
( ) to continue printing. However, graphics or characters with the error
492
Soft Reset(P. 451)