Upgrading Setpoint Files To A New Revision - GE MM300 Instruction Manual

SOFTWARE
Upgrading setpoint
files to a new revision
3–32
It is often necessary to upgrade the revision for a previously saved setpoint file after the
MM300 firmware has been upgraded. This is illustrated in the following procedure:
1. Establish communications with the MM300 relay.
2. Select the Online > Device Setup menu item and record the Firmware Revision from
the Device Setup window.
3. Load the setpoint file to be upgraded into the EnerVista SR3 Setup environment as
described in the section, Adding Setpoints Files to the Environment.
4. In the File pane, right-click on the saved setpoint file.
5. Note the File Version of the setpoint file. If this version is different from the Firmware
Revision noted in step 2, select a New File Version that matches the Firmware Revision
from the pull-down menu.
6. For example, if the firmware revision is 1.5x and the current setpoint file revision is
1.4x, change the setpoint file revision to "1.5x".
7. Enter any special comments about the setpoint file in the "Description" field.
8. Select the desired firmware version from the "New File Version" field.
9. When complete, click OK to convert the setpoint file to the desired revision. See
Loading Setpoints from a File below, for instructions on loading this setpoint file into
the MM300 .
CHAPTER 3: INTERFACING WITH THE MM300
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL