Connecting Enervista Mm300 Setup To The Relay; Configuring Serial Communications - GE MM300 Instruction Manual

CHAPTER 3: INTERFACING WITH THE MM300

Connecting EnerVista MM300 Setup to the relay

Configuring serial
communications
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
Before starting, verify that the cable is properly connected to either the USB port on the
front panel of the device (for USB communications) or to the Serial port on the rear of the
device. This example demonstrates a Serial connection.
1. Install and start the latest version of the EnerVista MM300/MM200 Setup software
(available from the GE Multilin web site). See the previous section for the installation
procedure.
2. Click on the Device Setup button to open the Device Setup window and click the Add
Site button to define a new site.
3. Enter the desired site name in the "Site Name" field. If desired, a short description of
the site can also be entered. In this example, we will use "New Site 1" as the site name.
4. The new site will appear in the upper-left list in the EnerVista MM300/MM200
Setup window.
5. Click the Add Device button to define the new device.
6. Enter the desired name in the "Device Name" field and a description (optional) of the
device.
7. Select "Serial Device" from the Interface drop-down list.
8. Click the Read Order Code button to connect to the MM300 device and upload the
order code.
9. Click OK when the relay order code has been received. The new device will be added
to the Site List window (or Online window) located in the top left corner of the main
EnerVista MM300/MM200 Setup window.
The MM300 Site Device has now been configured for Serial communications. Proceed to
Connecting to the Relay below, to begin communications.
SOFTWARE
3–25