Datalog - GE MM300 Instruction Manual

DATALOG

Datalog
6–6
Total Triggers
Range: 0 to 65535
A count of waveform triggers since the Clear Waveform command was sent.
The Home > Diag > Datalog page displays the MM300 datalog parameters. A typical
datalog page is shown below.
Figure 6-8: Datalog values
# of Triggers Since Clear
Range: 0 to 65535
Count of data log triggers since the Clear Data Logger command was sent.
# of Datalog Samples Stored
Range: 0 to 256
Count of the number of samples stored in the data log for the current trigger cause.
Trigger Cause
Range: None, Command, VO1 to VO32, Any Trip Pickup, Any Trip, Any Trip Dropout, Any
Alarm Pickup, Any Alarm, Any Alarm Dropout, Any Stop, Start A, Start B
Indicates the cause of the datalog trigger.
Trigger Date
Date of the current trigger.
Trigger Time
Time of the current trigger.
Datalog Status
Range: Stopped, Started, Triggered, Pretrigger, Posttrigger
Indicates the present status of the data log feature. Stopped and Started are used only in
Continuous mode. Triggered, Pretrigger, and Posttrigger are used only in Trigger Mode.
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: DIAGNOSTICS