Squeegee Drive Motor; Squeegee/Print Arm; Screen Adjustment/Micro-Registration; Squeegee Stroke Length Adjustment - MHM Synchroprint X-Type plus Operating Instructions Manual

7.9.2.

Squeegee Drive Motor

The squeegee/print arm motor is used to drive the squeegee carriage back and forth, precisely
controlled by the frequency converter.
7.9.3.

Squeegee/Print Arm

The squeegee carriage, squeegee stroke length adjustment, control keypad and control knobs for the
squeegee carriage speed & pressure are all located on the squeegee arm.
7.9.4.

Screen Adjustment/Micro-Registration

The screen adjustment/micro-registration is used for the precise positioning of the screens. Each
screen may be positioned forwards/backwards by means of a single handwheel adjuster located at
the front of each individual print station. For left/right adjustment there are two handwheel adjusters
located at the front and rear of each individual print station. Adjustment is free from play and self-
locking, therefore no additional clamping is required.
7.9.5.

Squeegee Stroke Length Adjustment

The squeegee stroke length adjustment may be used to adjust the precise travel of the squeegee
carriage. There are individual sensors on each print station to adjust the front and rear positions.
Minimizing the travel of the squeegee carriage helps to reduce printing times and increase
production.
7.9.6.

Squeegee/Print Arm Lock

Pressing the squeegee/print arm lock moves the entire squeegee/print arm upwards, providing un-
obstructed access to the screens.
7.9.7. Squeegee carriage speed & pressure controls
1
1... Adjustment for squeegee carriage speed forwards
2... Adjustment for squeegee carriage speed backwards
3... Adjustment for squeegee pressure (with clear display gauge)
Operating instructions X-Type plus V1-3.docx
Operating Instruction X-Type plus
2 3
Page 20 of 45