Transportation And Packaging; General Notes With Regard To Transportation And Danger Warnings; Packaging; Unloading Of The Crates - MHM Synchroprint X-Type plus Operating Instructions Manual

4. Transportation and packaging

This section provides an overview of the proper transportation of the Synchroprint.
4.1.

General Notes with Regard to Transportation and Danger Warnings

Danger of falling objects!
The following instructions must be observed
1. Never stand or walk under hanging loads!
2. Transportation must be carried out by qualified staff observing all safety
instructions.
3. The Synchroprint must only be lifted at the dedicated lifting points.
4. Only the lifting/handling devices and equipment indicated in this document
must be used for the movement of the Synchroprint. Non-compliance may
lead to serious damage of the Synchroprint and result in cancellation of the
warranty.
Upon delivery of the Synchroprint the consignment must be examined for
external damage immediately. In the case of any damages, they must be
documented and reported to Machines Highest Mechatronic GmbH within 24
hours.
4.2.

Packaging

The Synchroprint will be packed and delivered in several wooden crates. The crates' exact number,
weight and dimensions will vary slightly according to each model/type of machine. Contact
customer service for more information about individual orders.
4.3.

Unloading of the crates

The Synchroprint is to be unloaded by the customer. A forklift truck with adequate fork length and
lifting capacity (see 4.2 Packaging) will be required.
Danger of mechanical damage!
The Synchroprint must be lifted carefully and only at the dedicated lifting
points at the middle of the base unit. Lifting the Synchroprint at/by any other
point, especially the turntables, may result in serious damage. Be sure to
maintain an adequate and safe distance during lifting.
4.4.

Packaging material

After unpacking the machine, the packaging material must be disposed of according to local
regulations.
Operating instructions X-Type plus V1-3.docx
Operating Instruction X-Type plus
Page 12 of 45