External Supply/Connection Ports; Electrical Connections; Compressed Air - MHM Synchroprint X-Type plus Operating Instructions Manual

5.4.

External supply/Connection ports

Connections for compressed air and mains electricity are located on the base unit of the
Synchroprint as standard. Overhead supply connections may be ordered optionally but only at time
of order, to enable supplies to enter the machine from above, through the centre column.
Danger of tripping over!
In case of laying supply lines on the floor, it is necessary to attach step covers.
5.4.1.

Electrical Connections

Risk of electric shock!
Please observe the general safety regulations for electrical connections when
connecting the mains supply to the Synchroprint. Avoid any contact with live
components.
The electrical connections must be designed as follows:
Description
Supply voltage
Supply frequency
Connected load
All flash cure units must be supplied through a separate/independent
connection. Please observe the precise technical data from the flash cure unit
specification sheet.
5.4.2.

Compressed Air

Description
Max. air consumption (l/min)
Air pressure (minimum)
Air quality
Operating instructions X-Type plus V1-3.docx
Operating Instruction X-Type plus
Requirement/Value
1 x 200-240 V
50/60 Hz ±5 %
1.6 kVA + (0.4 kVA x „number of print heads")
(= "power for indexer main drive" + "power per print head" x
"number of print heads")
4/2 8/6
130 220
filtered, dry air supply only
(class 1:4:1 according ISO8573-1:2010)
X-Type plus
10/8 12/10
280 340
7 bar / 100 PSI
14/12
400
Page 14 of 45