Lamp Problems; Remote Control Problems; H Aving The P Rojector S Erviced - Eiki EK-610UA Owner's Manual

sequential timing.
6.
Set full screen mode.
7.
Turn on 3D glasses.
Problem: Image does not display in 3D
1.
Check if the battery of 3D glasses is drained
2.
Check if 3D glasses is turned on
3.
Check 3D supported format timings is correct or not
¾ 1280x720@120Hz frame sequential
¾ 1024x768@120Hz frame sequential

Lamp Problems

Problem: There is no light from the projector
1.
Check that the power cable is securely connected.
2.
Ensure the power source is good by testing with another electrical device.
3.
Restart the projector in the correct order and check if the Lamp LED indicator is flashing.
4.
If you have replaced the lamp recently, try resetting the lamp connections.
5.
Replace the lamp module.
6.
Put the old lamp back in the projector and have the projector serviced.
Problem: The lamp goes off
1.
Power surges can cause the lamp to turn off. Re-plug power cord. When the Lamp LED is red,
press " " on the built-in keypad or press "
2.
Replace the lamp module.
3.
Put the old lamp back in the projector and have the projector serviced.

Remote Control Problems

Problem: The projector does not respond to the remote control
1.
Direct the remote control towards remote sensor on the projector.
2.
Ensure the path between remote and sensor is not obstructed.
3.
Turn off any fluorescent lights in the room.
4.
Make sure that the batteries are installed with the correct polarity.
5.
Replace the batteries.
DLP Projector — Owner's Manual
" on the remote control to turn off the projector.
65
— —