NordicTrack Grand Tour User Manual page 11

10. Have a second person hold the Handlebar (7)
near the Handlebar Carriage (99).
Locate the remaining wire tie (F) in the
Handlebar Carriage (99). Tie the indicated
end of the wire tie to the two wires on the
Handlebar (7).
Next, pull the other end of the wire tie (F) until
the two wires are routed through the Handlebar
Carriage (99). Then, untie and discard the
wire tie.
11. Loosen the Handlebar Knob (95). Next, slide
the Handlebar Carriage (99) forward as far as
possible. Then, tighten the Handlebar Knob.
Tip: Avoid pinching the wires. Attach the
Handlebar (7) to the Handlebar Carriage (99)
with four M6 x 20mm Screws (103); start all the
Screws, and then tighten them.
12. Hold the Console Bracket (33) near the
Handlebar Carriage (99). Insert the Main Wire
(68) and the two wires (G) from the Handlebar
(7) upward through the Console Bracket.
Tip: Avoid pinching the wires. Attach the
Console Bracket (33) to the Handlebar Carriage
(99) with three M6 x 16mm Screws (107); start
all the Screws, and then tighten them.
Then, press the Wire Cover (32) onto the
Console Bracket (33).
10
7
F
11
103
7
99
12
Avoid pinching
the wires
7
11
99
Avoid pinching
the wires
95
G
32
68
33
107
99
107