Page 1
Model No. NTCCEX04902 Serial No. Serial Number Decal If you require SERVICE for this product, please call SEARS: 1-800-4 MY HOME (469-4663) If you are MISSING PARTS or require INFORMATION on how to operate this product, call 1-888-936-ICON (4266) CAUTION...
ASSEMBLY Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable wrench Use the drawings below to identify the small parts used in assembly.
Page 5
2. Hold the Upright (2) near the front of the Frame (1) as shown. Connect the Extension Wire (66) to the Wire Harness (22). Attach the Upright to the Frame with four M6 x 12.7mm Button Screws (62), four M6 Split Washers (57), and four M6 Flat Washers (67).
Page 6
5. Attach the Seat (10) to the Seat Carriage (6) with four M6 x 16mm Button Screws (68) and four M8 Flat Washers (80). 6. Attach the Seat Back (9) to the Seat Carriage (6) with four M6 x 16mm Button Screws (68). 7.
Page 7
8. Position the Seat Carriage (6) as shown. Slide the Seat Rail Cover (84) into the slot in the Seat Rail (7). The beveled end of the Seat Rail Cover should be flush with the end of the Seat Rail. Attach a Seat Stop (77) and the Seat Rail Cover to the Seat Rail with an M4 x 16mm Screw (64).
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (see page 11), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor. 1. Remove the four indicated screws from the back of the Console (3).
HOW TO OPERATE THE RECUMBENT CYCLE HOW TO ADJUST THE PEDAL STRAPS To adjust the pedal straps, first pull the straps off the tabs on the pedals. Move the Strap straps to the desired position and press the straps back onto the tabs.
HOW TO USE THE MANUAL MODE Turn on the console. To turn on the console, press the Reset button or begin pedaling. Select the manual mode. Each time the This corner console is should be blank turned on, the manual mode will be selected.
Page 11
HOW TO USE A SMART PROGRAM Turn on the console. See step 1 on page 10. Select one of the four Smart programs. Each time the console is turned on, the manual mode will be selected. To select a Smart program, press the Program Select button repeatedly until the number 1, 2, 3,...
MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the recumbent cycle regularly. To clean the recumbent cycle, use a soft, damp cloth. To prevent damage to the console, keep liquids away from the console, keep the console out of direct sun- light, and remove the batteries when storing the recumbent cycle.
EXERCISE GUIDELINES WARNING: • Before beginning this or any exercise pro- gram, consult your physician. This is espe- cially important for individuals over the age of 35 or individuals with pre-existing health problems. • The pulse sensor is not a medical device. Various factors may affect the accuracy of heart rate readings.
• the KEY NUMBER and DESCRIPTION of the part(s) (see page 14) NordicTrack is a registered trademark of ICON Health & Fitness, Inc. ICON OF CANADA, INC., (ICON), warrants this product to be free from defects in workmanship and mate- rial, under normal use and service conditions, for a period of one (1) year from the date of purchase.