NordicTrack Grand Tour User Manual page 10

8. Have a second person hold the Handlebar Post
(6) near the Frame (2).
Locate the long wire tie (B) in the Handlebar
Post (6). Tie the lower end of the long wire tie to
the Main Wire (68).
Next, locate the middle of the long wire tie (C) in
the access hole (D) in the Handlebar Carriage
(99). Pull the long wire tie upward until the end of
the Main Wire (68) is in the access hole.
See the inset drawing. Next, pull the free end
of the long wire tie (B) until the Main Wire (68) is
routed through the Handlebar Carriage (99) as
shown. Then, untie and discard the long wire tie;
do not remove the short wire tie.
9. Tip: Avoid pinching the Main Wire (68) during
this step.
Locate the Post Knob (47) near the front of the
Frame (2). Loosen and pull the Post Knob.
Next, insert the Handlebar Post (6) into the
Frame (2), and release the Post Knob (47) into
the lowest adjustment hole (E) in the Handlebar
Post. Then, tighten the Post Knob. Note: After
the exercise bike is assembled, you can adjust
the Handlebar Post to the desired height.
8
6
68
2
9
Avoid pinching the
Main Wire (68)
2
47
10
C
99
B
D
B
68
99
B
6
E
68