Kemppi FastMig MXF65 Operating Manual page 7

• Never lift a gas cylinder and the welding machine at the same time. There are separate
provisions for gas cylinder transportation.
• Never use a welding machine when suspended unless the suspension device has been
designed and approved for that particular purpose.
• Do not exceed the maximum allowable load of suspension beams or the transportation
trolley of welding equipment. It is recommended that the wire coil be removed during
lifting or transportation.
environment
• Welding equipment is not recommended for use in rain or snow - see manual. Protect the
equipment against rain and strong sunlight. Always store the machine in a dry and clean
space.
• Protect the machine from sand and dust during use and in storage. The recommended
operating temperature range is -20 to +40 °C. The machine's operation efficiency decreases
and it becomes more prone to damage if used in temperatures in excess of 40 °C.
• Place the machine so that it is not exposed to hot surfaces, sparks or spatter.
• Make sure the airflow to and from the machine is unrestricted.
• EMC classification of this product is class A in accordance with electromagnetic
compatibility standards CISPR 11 and IEC 60974-10, and therefore the product is designed
to be used in an industrial environment only.
WARNING: This class A equipment is not intended for use in residential locations where
the electrical power is provided by a public low-voltage supply system. In those locations
it may be difficult to ensure the electromagnetic compatibility due to conducted and
radiated disturbances.
• Arc welding equipments cause electromagnetic disturbance. To minimize the harmful
effects, strictly use the equipment according to the operating manual and other
recommendations.
gas bottles and pneumatic devices
• Adhere to the instructions for handling pneumatic devices and gas bottles.
• Make sure that gas bottles are used and stored in properly ventilated spaces.
• A leaking gas bottle may replace the breathable air, causing suffocation.
• Before use, make sure that the gas bottle contains gas suitable for the intended welding
purpose.
• Always fix the gas bottle securely in an upright position, against a bottle wall rack or
purpose-made bottle cart.
• Never move a gas bottle when the regulator or flow adjuster is in place. Replace the valve
cover during transportation. Close the bottle valve after use.
disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
EN
5