Loading Paper Into The Bypass Tray - Ricoh MP C3504 Series User Manual

9. Adding Paper and Toner
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in Trays 2–4 by adjusting the positions of side fences and
end fence. For details, see "Changing the Paper Size in Trays 2 - 4", Paper Specifications and
Adding Paper.
• You can load envelopes in Trays 2–4. When loading envelopes, place them in the correct
orientation. For details, see page 178 "Envelopes".

Loading Paper into the Bypass Tray

Use the bypass tray to use OHP transparencies, adhesive labels, translucent paper, and paper that
cannot be loaded in the paper trays.
154
DLV106
DLV107