Loading Tab Stock Into Tray 2; Loading Paper Into The Multi Bypass Tray (Tray A) - Ricoh Pro C7500 Operator's Manual

2. Paper Specifications and Adding Paper

Loading Tab Stock into Tray 2

• When loading tab stock, always use the tab sheet holder.
• Load tab stock so that the side with the tab faces the tab sheet holder.
• When loading tab stock, adjust the fence position so that the tab sheet holder will fit the tab stock.

Loading Paper into the Multi Bypass Tray (Tray A)

Use the multi bypass tray (Tray A) to use transparencies, translucent paper, and paper that cannot be
loaded in the paper trays.
• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see below.
• See page 101 "Recommended Paper Sizes and Types".
• Check the paper edges are aligned at the left side.
• When loading a low number of sheets, be sure not to squeeze the fences in too tightly. If the fences
are squeezed too tightly against the paper, the edges may crease, the paper may misfeed, or if it
weighs between 52.3–63.0 g/m
76
M0EBIM2115
M0EBIM2116
2
(14.0–16.9 lb. Bond), it may wrinkle.