Siemens Gigaset A580 IP User Manual page 127

Web configurator – Setting the phone using a PC
Area: Settings for Bandwidth
The settings in this area influence all VoIP connections (VoIP phone numbers).
Allow 1 VoIP call only
You can usually make two VoIP calls at the same time on your phone. If, how-
ever, your DSL connection has a narrow bandwidth, there may be problems if
two VoIP calls are made at the same time. The data is no longer transferred
properly (long voice delay, data losses etc.).
¤
Select
phone connections being established.
¤
If you wish to permit two VoIP connections, select No.
Please remember
If only one VoIP connection is permitted, the following VoIP network services
will no longer be available:
u
Call waiting
Call waiting is not displayed during a call via VoIP.
u
External consultation call from a VoIP call
u
Toggling and initiating a conference call via VoIP
Voice Quality
Default settings for the codecs used are stored in your phone: one setting opti-
mised for low bandwidths and one for high bandwidths.
¤
Activate one of the options
bandwidth
The settings are shown in the
changed.
¤
Activate the
tion-specific voice codecs yourself (
Area: Settings for Connections
In this area you can make specific settings for each of your VoIP phone num-
bers.
You can make the following settings for each VoIP phone number configured
on your phone:
Volume for VoIP Calls
Depending on the VoIP provider, it is possible that the received voice/earpiece
volume is too low or too high, so that adjusting the volume via the handset is
not adequate.
Specify whether the received volume range is too high or too low. The follow-
ing options are available:
Low
Voice/earpiece volume is too high. Activate this option to reduce the volume
by 6 dB.
Normal
The voice/earpiece volume does not need to be raised/lowered.
126
Yes next to Allow 1 VoIP call only
if you wish to accept a default setting for all VoIP connections.
Own Codec preference
to prevent any further parallel VoIP
Optimized for low bandwidth
Settings for Connections
option if you wish to select and set connec-
¢
"Area: Settings for
/ Optimized for high
area and cannot be
Connections").