Ide, Cdrom Hard Drive Connector (Cn27); Connecting The Hard Drive; Solid State Disk; Compactflash (Cn11) - Advantech PCM-4380F-M0A2E User Manual

2.6 IDE, CDROM hard drive connector (CN27)

The board provides 1 IDE channels which you can attach up to two
Enhanced Integrated Device Electronics hard disk drives or CDROM to
the board's internal controller. Its IDE controller uses a PCI interface.
This advanced IDE controller supports faster data transfer, PIO mode 3,
mode 4 and up to UDMA/33.
2.6.1

Connecting the hard drive

Connecting drives is done in a daisy-chain fashion. This package includes
One 44PIN IDE cable that can connect to 1.8" and 2.5" drives.
1. Connect one end of the cable to Hard Drive connector. Make sure
that the red (or blue) wire corresponds to pin 1 on the connector,
which is labeled on the board (on the right side).
2. Plug the other end of the cable into the Enhanced IDE hard drive,
with pin 1 on the cable corresponding to pin 1 on the hard drive.
(See your hard drive's documentation for the location of the con-
nector.)
If desired, connect a second drive as described above.
Unlike floppy drives, IDE hard drives can connect to either end of the
cable. If you install two drives, you will need to set one as the master and
one as the slave by using jumpers on the drives. If you install only one
drive, set it as the master.

2.7 Solid State Disk

The board provides a CompactFlash™ card type I/II socket.
2.7.1

CompactFlash (CN11)

The CompactFlash card shares a secondary IDE channel which can be
enabled/disabled via the BIOS settings.
PCM-4380 User Manual 14