Table of Contents
Advertisement
2.5 Installing SO-DIMM
PC Board
Module Tilted
Approximately 25
The procedures for installing SODIMMs are described below. Please fol-
low these steps carefully. You can install SDRAM memory modules
using 200-pin SODIMMs (Small Outline Dual In-line Memory Modules).
1.
Ensure that all power supplies to the system are switched off.
2.
Tilt the SODIMM card approximately 25o above the board, and
move it in the direction of the housing card slot. Make sure that the
key in the module and the key in the housing are aligned.
3.
Push the module into the socket until the module bottoms. There
should be a slight insertion force to engage the module into the con-
tacts.
Module Key Aligned
With housing Key
2
1
Housing
Card Slot
13
3
Module Latching
Ledge(TO Engage
Edge of Module)
Chapter 2
Advertisement
Table of Contents
