H3C S5500-SI Series Operation Manual page 1108

Follow the steps below to load a patch file:
To do...
Enter system view
Load the patch file from the
flash to the memory patch area
Activating Patches
After you activate a patch, the patch will take effect and is in the test-run stage. After the switch is reset
or rebooted, the patch becomes invalid.
If you find that an ACTIVE patch is of some problem, you can reboot the switch to deactivate the patch,
so as to avoid a series of running faults resulting from patch error.
Follow the steps below to activate patches:
To do...
Enter system view
Activate the specified patches
Confirming Running Patches
After you confirm the running of a patch, the patch state becomes RUNNING, and the patch is in the
normal running stage. After the switch is reset or rebooted, the patch is still valid.
Follow the steps below to confirm the running of the patches:
To do...
Enter system view
Confirm the running of the
specified patches
This operation is applicable to patches in the ACTIVE state only.
One-Step Patch Uninstallation
On a centralized device
You can use the undo patch install command to uninstall all patches. The patches then turn to the
IDLE state. This equals execution of the commands patch deactive and patch delete.
On a distributed device
Use the command...
system-view
patch load
Use the command...
system-view
patch active patch-number
Use the command...
system-view
patch run patch-number
1-7
Remarks
—
Required
Remarks
—
Required
Remarks
—
Required