H3C S5500-SI Series Operation Manual page 1110

Displaying and Maintaining Hotfix
To do...
Display the patch information
Hotfix Configuration Examples
Hotfix Configuration Example
Network requirements
The software running on Device is of some problem, and thus hotfixing is needed.
The patch file patch_xxx.bin is saved on the TFTP server.
The IP address of Device is 1.1.1.1/24, and IP address of TFTP Server is 2.2.2.2/24. An available
route exists between Device and TFTP server.
Figure 1-6 Network diagram of hotfix configuration
Configuration procedure
1) Configure TFTP Server. Note that the configuration varies depending on server type and the
configuration procedure is omitted.
Enable the TFTP server function.
Save the patch file patch_xxx.bin to the directory of the TFTP server.
2) Configure Device
Make sure the free flash space of the switch is big enough to store the patch file.
# Before upgrading the software, use the save command to save the current system configuration. The
configuration procedure is omitted.
# Load the patch file patch_xxx.bin from the TFTP server to the root directory of the Flash.
<Device> tftp 2.2.2.2 get patch_xxx.bin
# Install the patch.
<Device> system-view
[Device] patch install flash:
Patches will be installed. Continue? [Y/N]:y
Do you want to continue running patches after reboot? [Y/N]:y
Use the command...
display patch information
1-9
Remarks
Available in any view