Before Connecting Cables - Samsung OH24E User Manual

Before connecting cables

― Model OH24E is only supported.
Silicone-Bar
Unfasten the screws, then remove the cover.
Remove the appropriate silicon bar for the
thickness of the cable to connect.
Different hole sizes and corresponding cable
thickness for each:
― 7 Ø hole x 1: Insert the 7 Ø cable
― 5.5 Ø hole x 2 : Insert the 5.5 Ø cable
― 3 Ø hole x 2 : Insert the 3 Ø cable
Insert and keep the removed Silicone-Bar in the
marked area to ensure it is not lost.
Insert the appropriate cable into the hole from
which the Silicone-Bar was removed.
The cable should be connected as shown.
Close the cover, then fasten the screws.
― After all the cables are connected, make sure to
close the cover and fasten the screws to ensure
it is water tight.
― Recommended torque : 7 - 8 kgf.cm
38