TOHATSU MFS 15 Owner's Manual page 59

58
INSPECTION AND MAINTENANCE
4. Remove the spark plugs by turning it
counter-clockwise, using a 5/8" socket
wrench and handle.
5. Attach spark plug and tighten to speci-
fied torque.
Use spark plug NGK DCPR-6E.
1
2
1. Electrode
2. Spark gap (0.8–0.9 mm, 0.031–0.035 in)
ENON00028-0
Note
Spark plug torque:
18.0 Nm (13.3 ft-lb) [1.84 kgf-m]
If a torque-wrench is not available when you
are fitting a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 a turn past
finger-tight. Have the spark plug adjusted to
the correct torque as soon as possible with
a torque-wrench.
ENOM00088-0
Replacing the anode
The anode protects the outboard motor
from galvanic corrosion (metal corrosion
caused by feeble electricity).
Anodes are installed under the anti-ventila-
tion of the gear case, the left cramp
bracket (port side) and the left mount
bracket (port side).
When an anode is worn down under 2/3 of
its original size (of new port), replace it.
ENON00029-0
Notes
Never grease or paint the anode.
1. Anode (Trim tab)
ENOF00085-0
1. Anode
1. Anode
At each inspection re-tighten the anode
attaching bolt. As it is likely to be sub-
jected to electrolytic corrosion.
1
1
1
1
ENOF00086-0
ENOF00334-0
ENOF00335-0