TOHATSU MFS 15 Owner's Manual page 32

1
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb while engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
For USA and Canada model
1. Full open the air vent screw on the tank
cap.
2. Loosen the tank cap until contacts the
tab lock and release internal pressure
completely. After that, close the tank
cap until two clicks sound is heard.
3. Connect the fuel connector to the
engine and squeeze primer bulb until it
becomes stiff to feed fuel to carburetor.
Direct arrow mark upward when prim-
ing.
ENOF00310-0
ENOF00032-0
2
ENGINE OPERATION
1
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb while engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
ENOW00030-0
CAUTION
When using EPA approval fuel tank, only
use a primer bulb/hose assembly that has
a Fuel Demand Valve installed in the fuel
hose or a sealing mechanism in the fuel
connector as shown below.
(FDV and fuel connector that has an seal-
ing mechanism prevent pressurized fuel
from entering the engine and causing a fuel
system overflow or possible fuel spillage.)
31
ENOF00311-0
ENOF00032-0
2