TOHATSU MFS 15 Owner's Manual page 43

42
ENGINE OPERATION
DN
ENOM00058-0
Improper Trim Angle (bow dips into
the water)
If the trim angle is too small, the bow will
dip into the water, the speed will decrease,
and water may enter the boat. In this case,
the trim angle should be increased by
pressing the switch on the remote control
lever to "UP".
UP
ENOM00059-0
Proper Trim Angle
The trim angle is optimum when the boat
is parallel to the water surface while run-
ning.
EFT type
ENOF00056-0
1. Power tilt switch
EPT type
1. Power tilt switch
ENOW00043-0
Do not put hand or finger in between
outboard motor body and clamp bracket
when adjusting trim angle to prevent
ENOF00057-0
injury in case the outboard motor body
falls.
Unsuitable trim position can cause loss
of control of boat.
When testing a trim position, run boat
slow initially to see if it can be controlled
safely.
ENOW00044-0
Excessive trim up or down may lead to
unstable boat operation, potentially caus-
1
UP
DN
1
WARNING
WARNING
ENOF00343-0
ENOF00324-0