Hardware Interface Configuration - Honeywell Excel 50 User Manual

Hide thumbs Also See for Excel 50:

Installation instructions manual (40 pages)

User manual (72 pages)

Table Of Contents

Table of Contents

EXCEL 50 - USER GUIDE

The following sequence will depend upon the specific hardware interfaces featured

on the controller. The list box will contain a combination of the following options: B-

port (serial port), C-bus, LON-bus, or Modem (RS232 serial port).

HW-Interf. Cfg.

B-Port

C-Bus

LON-Bus

B-Port

Using the arrow keys, move the cursor to the 'B-Port' field. Confirm with ENTER.

B-Port Config.

Baudrate<

Using the arrow keys, move the cursor to the value field. Confirm with ENTER.

NOTE: Changing the baud rates requires a level-2 password.

Change the values using the '+' or '–' keys. Confirm with ENTER. Using the arrow

keys, move the cursor to 'BACK' and confirm with ENTER.

C-Bus

Using the arrow keys, move the cursor to the 'C-Bus' field. Confirm with ENTER.

C-Bus Config.

Baudrate:<

Contr.No: ›1

Bus ID

NOTE: If you set the bus ID to a non-zero value, the C-bus baudrate will be

immediately disabled (i.e. it is then no longer editable). See also

section "L

Using the arrow keys, move the cursor to the value field. Confirm with ENTER.

NOTE: Changing the baud rates requires a level-2 password.

NOTE: To provide compatibility with the PC-based XL-Online operator and service

software, this C-Bus screen may appear even for controllers with

application modules that do not have a C-Bus connection. This screen will

not appear for controllers using the XD50E application module, which does

not allow downloads.

Change the values using the '+' or '–' keys. Confirm with ENTER. To change the

controller number, repeat previous steps. Using the arrow keys, move the cursor to

'BACK' and confirm with ENTER.

Bus

Using the arrow keys, move the cursor to the 'LON-Bus' field. Confirm with ENTER.

ORKS

LON-Bus Config.

Contr. Neuron ID

neuron ID no.

This screen displays the unique ID number of the Neuron processor. Using the

arrow keys, move the cursor to 'BACK' and confirm with ENTER.

Modem

Using the arrow keys, move the cursor to the 'Modem' field. Confirm with ENTER.