Table of Contents
Advertisement
BMS-4 Akkumat
4 Installation of stud welder
• Only install the stud welder on an even surface. The anti-vibration pads located on the bottom of the
welding equipment guarantee its anti-skid position and serve as vibration dampers.
• Although the stud welder is resistant to environmental influences, it should be protected against
dampness and dust.
• Please pay particular attention to the bearing strength of the workshop furniture and ensure a safe
and stable position of the welding equipment.
• Make sure there is sufficient free space around the air apertures, otherwise the device safety
mechanism will respond and interrupt the welding process.
• Install the stud welder close to the welding location.
• Ensure sufficient ventilation of the working room when operating the welding system.
NOTE
The housing of the stud welder corresponds to safety class IP 21. Please observe that
this system of protection is not suitable for being operated or transported in the rain.
• Ensure correct connected loads for electrical connections as indicated on the type plate
and/or battery charger.
17
Advertisement
Table of Contents
