INSTALLATION INSTRUCTIONS
Packing Material
Remove protective packing material from oven. Tape
residue can be cleaned with a soft cloth and alcohol.
Lean oven to each side and remove shipping base.
Oven Location
Choose a location on the following factors.
• Make sure there is adequate space for proper
installation.
• Carefully read all instructions before beginning
installation.
• Make sure cabinet base is level.
Cabinet Opening Double Wall Oven
Prepare the cabinet for wall oven.
A---52 3/8 inches
B---25 inches
C---24 inches
D---27 inches
E---12 ½ inches
F---3 inches
Electrical Supply Location
Electrical supply must be located in the area shown.
Electrical Connection for Double Wall Oven
A---5 inches
B---16 inches
Electrical Connection Requirements
Line voltage must not exceed rated voltage. Line
voltage less than rated voltage will result in slow
heating.
Wiring system must conform to U.L.
Standards and National Electrical Code. Installation
must conform to all local, municipal and state building
codes, and local utility regulations. Oven must be
connected only to a supplied circuit as specified on
rating plate.
This oven requires 3 wires, 115/230-120/240 volts, 60
Hertz AC. Unit is equipped with a No. 10 ground wire
in conduit. Oven should be fused separately from other
appliances on a 40 amp circuit minimum. Verify
electric power is off from fuse box to junction box until
oven is installed and ready to operate.
19