Table of Contents
Advertisement
Installation
Site Preparation
Note: It is recommended that a thorough
site inspection be conducted PRIOR to
unpacking and moving this appliance.
• WARNING: DO NOT use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. Make sure pins are
inserted into hinges before removing door
to prevent personal injury to hands and/or
fingers. Do not lift or carry the door by
the handle.
• Confirm available access to adequate
power – see electrical requirements. Single
oven units require a 30 amp circuit.
Note: A minimum of 5.1 cm spacing above
and below the oven to any adjacent items is
required for ventilation purposes.
Installation Procedure
Door removal is for standard electric and lower french door oven models.
DO NOT remove the single / upper double french doors during installation.
1
Remove wooden brace on front of pallet.
• It is recommended that 1.9 cm or larger
material be utilized to create a support
platform for this appliance.
• BE SURE that support for this appliance is
perpendicular to the front facing of the
wall or cabinet before you perform the
installation.
• Use of a hydraulic lift is recommended for
the installation of double oven units.
• All openings in the wall behind the
appliance or in the floor under the
appliance should be sealed.
• Keep appliance area clear and free from
combustible materials, gasoline and other
flammable vapors.
• WARNING: DO NOT USE AN
EXTENSION CORD WITH THIS
APPLIANCE. SUCH USE MAY RESULT IN
FIRE, ELECTRICAL SHOCK OR OTHER
PERSONAL INJURY.
2
Open door completely. Place pin in pin hole.
16
Advertisement
Table of Contents
