Installation; Site Preparation; Installation Procedure - Viking VCSO244 Installation Manual

Installation

Site Preparation

• All openings in the wall behind the oven
NOTE: It is recommended that a thorough
site inspection be conducted PRIOR to
• Keep oven area clear and free from
unpacking and moving this appliance.
W R N I N G
DO NOT use the handle or appliance
door to lift the appliance. Remove door
before installation to ensure that it is not
used to lift the unit. Do not lift or carry
the door by the handle.
*
Refer to the Use & Care Manual for
properly removing the door.
• Confirm available access to adequate
power – see electrical requirements.
• It is recommended that 3/4" or larger
material be utilized to create a support
platform for this appliance.
• BE SURE that support for this appliance is
perpendicular to the front facing of the
wall or cabinet before you perform the
installation.

Installation Procedure

1
Place the oven in front of the cabinet opening.
7
or in the floor under the oven should be
sealed.
combustible materials, gasoline and other
flammable vapors.
W R N I N G
DO NOT use an extension cord with this
appliance. Such use may result in fire,
electrical shock or other personal injury.
2
Feed the flexible cable conduit from the oven through
the opening in the cabinet.
3
Remove the junction box cover.
ground wire inside the junction box. Connect black and
red wires from oven to matching color wires from supply
5
Insert oven into the cabinet opening.
pinching the conduit between the oven and the wall. Be sure
Professional Trim Kit Professional Trim Kit Professional Trim Kit
7A
Open the oven door and attach the oven to the front of
the cabinet with 4 screws.
8
4
Black
Strain
relief
Green
Red
Connect green wire from oven to the supply cable
cable in junction box.
6
Push the oven in and against the cabinet until the lateral
holders of the oven touch the front of the cabinet. Avoid
the oven is placed at the center of the opening.
Designer Trim Kit Designer Trim Kit Designer Trim Kit
7B
Open the oven door. Pass the trim kit over the door
towards the front of the cabinet.