Viking VEDO 273 Service Notebook page 30

Electric wall oven
Table of Contents

Advertisement

COMPONENT TESTING INFORMATION
Illustration
Component
See illustrations
Mylar touch system
above.
ERC5800
ERC5800
Oven temperature
Control
adjustment.
ERC5800
Twelve hour off
ERC5800
Child lock out
Control
ERC Mylar touch system -- ERC5800
Test Procedure
F1 - Control malfunction.
F2 - Oven over temperature.
F3 - Open sensor or sensor circuit
F4 - Shorted sensor or sensor circuit
F7 - Shorted input key.
F9 - Door lock or door lock circuitry
malfunction (door unlocked)
FF - Door lock or door lock circuitry
malfunction (door locked)
DOOR - lock status is not sensed
within 90 seconds of energizing door
lock relay.
Press BAKE
Press + slew pad until an oven
temperature greater than 500° shows
on display. Immediately press and
hold BAKE until "00" appears in
display, approximately 5 seconds.
To decrease oven temperature (for a
cooler oven), press - slew pad until
negative numbers appear. Oven can
be adjusted from -5 to -35 degrees lower .
To avoid over adjusting oven move
temperature -5 degrees each time.
To increase oven temperature (for
warmer oven), press + slew pad until
positive numbers appear. Oven can
be adjusted 5 to 35 degrees higher.
To avoid over adjusting oven move
temperature 5 degrees each time.
Press OFF CANCEL. Temperature
Adjustment will be retained even
through a power failure.
Control will automatically cancel any
baking operation and remove all relay
drives 12 hours after the last pad touched.
This is a safety feature that can be used
to prevent children from accidentally
programming the oven. It disables the
electronic oven control. Press and hold
BAKE and BAKE TIME for 5 seconds.
"OFF" will display where the tempera-
ture normally appears. To reactivate the
control press and hold BAKE and BAKE
TIME for 5 seconds. Child lockout feat-
ure must be reset after a power failure.
30
Results
Test mylar touch pad.
Check sensor wiring, sensor, and
temperature limiter.
Check sensor resistance and wiring.
Check sensor resistance and wiring.
Verify mylar switch connections,
replace mylar touch pad.
Check latch switch.
Check latch switch.
Verify operation of door latch
switches.
While increasing or decreasing oven
temperature, this does not affect self-
cleaning temperature.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents