Operating The Unique; Selecting The Location; Putting Into Operation - Look Solutions Unique 2.1 Operating Manual

From the finest mist to a thick haze, similar to fog, any desired effect can be achieved.
These haze effects form slowly so that the device should be switched on some time
before the lighting or the laser start to operate.
Important: Do not connect a ducting to the nozzle of the Unique 2.1. If a ducting is
connected directly to the machine the haze will be pushed back into it. This may damage
the machine. We cannot grant warranty in this case!

5.1 Selecting the location

The location in which the Unique 2.1 is to be operated must
– be dry,
– be free from dusty or polluted air,
– be free from vibrations,
– be a non-flammable place or surrounding,
– be well-ventilated with haze-free air keeping the ambient operating temperature
between 50° F and 105° F and the relative humidity below 80%.

5.2 Putting into operation

Warning: Never connect the Unique 2.1 to a dimmer or switchpack! This may destroy
the machine.
a. Connect the power plug to the mains supply. Make sure
the correct voltage is selected.
A P and two figures appear on the LED-display [17].
b. After 60 Seconds, the Unique 2.1 is heated up. Press the Enter-button [16] once to
start the haze process. The green Active-LED [18] will be lit. After a short delay the
machine begins to haze.
After 30 Seconds the display will go dark. To re-activate it, press one of the buttons
on the display.

5. Operating the Unique 2.1

9
P 2 5