Switching The Device Off; Control Choices - Look Solutions Unique 2.1 Operating Manual

5.3 Switching the device off

a. Press the Mode button [14] till „OFF" appears on the display.
After 15 Seconds the machine will switch into the post-run-
mode automatically. On the LED display lines appear which
move from upper left to the lower right while the heater is
cooling.
To cut this process short, the air pump works with full power
for a short time and also put all remaining fluid out of the va-
porizer. The remaining fluid will maybe come out as a bigger
haze cloud. This is normal and no failure of the machine.
When the heater is cooled down, a red decimal point will appear on the right bottom
edge of the display.
b. When you switch off the DMX signal, the machine will be switched into the post-
run-mode to cool down automatically after 15 Seconds.
Note: Please make sure that the Unique
the fan to run until the device has cooled down. This will ensure that no fluid remains
in the vaporizer to come out as droplets when the device is switched on next time.

5.4 Control choices

20: Profile/
Timer-LED, red
18: Active-LED, green
19: DMX-LED, yellow
14: Mode-button
15: Up/Down-button
5. Operating the Unique 2.1
P. = pause
1. = pause
timer
profile
active
dmx
in
Fig. 1: Adjusting the pump output
2
will not be disconnected too early to allow
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
P 1 5
XXX = address PXX = pump FXX = fan
· ·
10
_ _
_
P. = pause F. = fogtime
(min) · (sec)
1. = pause 2./3./4. = level a 5./6./7. = level b
· ·
timer
profile
.
active
dmx
in
XXX = address PXX = pump FXX = fan
· ·
17: Led-Display
16: Enter-button