Look Solutions Unique 2.1 Operating Manual page 11

P. = pause
1. = pause
timer
profile
active
dmx
in
XXX = address
Fig. 2: Adjusting the fan output
P. = pause
1. = pause
timer
profile
active
dmx
in
XXX = address
Fig. 4: Changing to the Profile-Mode
You may control the Unique 2.1 externally through the XLR sockets [2 and 3].
Please note: DMX takes priority. That means: when the machine is controlled via DMX
512 this data takes priority over 0-10V (+) DC and Stand alone operation.
Please note: You can't hold down the Mode-button for scrolling through the Menu.
The Mode-button has to be pressed only momentarily. If the Mode-button is pressed
more than two Seconds, the machine will change into the Timer-Mode (see point
5.4.5).
An outstanding feature is the adjustable output of the Unique 2.1. The pump and
the fan can be easily and separately adjusted and regulated in 99 steps via buttons.
Any desired effect can be achieved in steps of 1%: from the finest mist to a thick haze,
similar to fog. To achieve the thickest effect the pump must run at 99%, the fan at 1%.
The finest haze can be achieved with lower pump and higher fan settings. The data
can be readjusted whenever you want to.
5.4.1 Operating via DMX 512
Connecting the Unique 2.1 to a DMX desk, use the XLR socket [2] beside the control
panel. As soon as the machine receives a correct DMX signal, the yellow DMX-LED [19]
will be lit. Please note: The Unique 2.1 uses two channels on your desk! First Channel
= Pump, second Channel =Fan
5. Operating the Unique 2.1
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
F 7 5
PXX = pump FXX = fan
· ·
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
P r o
PXX = pump FXX = fan
· ·
P. = pause
1. = pause
timer
profile
active
dmx
in
Fig. 3: Adjusting the DMX-start address
P. = pause
1. = pause
timer
profile
active
dmx
in
Fig. 5: Switching the device off
11
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
2 7 5
XXX = address PXX = pump FXX = fan
· ·
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
O F F
XXX = address PXX = pump FXX = fan
· ·