Stand Alone Mode - Look Solutions Unique 2.1 Operating Manual

5.4.3 Stand alone
The Unique 2.1 can be used in the Stand alone mode. In this mode all data for the
pump and the fan must be adjusted directly at the machine.
5.4.3.1 Adjusting the pump and fan output
a) Press the Mode-button [14] at the control panel until a P and two figures appear on
the LED-display [17] (see Fig. 1).
b) Adjust the desired data (1 - 99%) by pressing the Up- or Down-button [15].
c) Press the Mode-button [14] again until an F and two figures appear on the display
[17] (see Fig. 2).
d) With the Up- or Down-button [15] the fan data can now be adjusted.
e) Press the Enter-button [16] once to start the machine. The green Active-LED [18] will
be lit.
5.4.4 Haze-Density Control System (HDCS)
P. = pause
1. = pause
timer
profile
active
dmx
in
XXX = address
Fig. 6: Adjusting the Pause
P. = pause
1. = pause
timer
profile
active
dmx
in
XXX = address
Fig. 8: Start the profile
5. Operating the Unique 2.1
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
1.0.1
PXX = pump FXX = fan
· ·
(Pre-Runtime)
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
r u n
PXX = pump FXX = fan
· ·
P. = pause
1. = pause
timer
profile
active
dmx
in
Fig. 7: Adjusting the pump
P. = pause
1. = pause
timer
profile
active
dmx
in
Fig. 9: Quit the profile
13
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
2.6 3
XXX = address PXX = pump FXX = fan
· ·
F. = fogtime
(min) · (sec)
2./3./4. = level a 5./6./7. = level b
· ·
E S C
XXX = address PXX = pump FXX = fan
· ·