Stand Alone Mode; Control Via Radio Remote - Look Solutions Viper 2.6 Operating Manual

5.4.4 Stand alone
The Viper 2.6 can be used in the Stand alone mode. In this mode the control of
the pump and the fan must be adjusted at the machine.
a) Press and release the Mode-button [16] until a „P" and two figures appear on
the display [20].
b) Adjust the pump output with the Up/Down-buttons [17] and press the Enter-
button [18] once to start the fogging process.
The machine now produces fog until the Enter-button is pressed again.
The output can be changed during the fogging process.
To adjust the fan output
a) press the Mode-button [16] again, until a „F" and two figures appear on the
display [20].
b) Adjust the fan output with the Up/Down-buttons [17].

5.4.5 Control via Radio remote

A radio remote is available as an option. It will be delivered with a 3pin XLR
plug.
Connect the receiver of the radio remote to the machine, using the 3pin XLR
socket [10] on the back of the machine.
Adjust the requested pump output at the machine (see point 5.4.4).
Press and hold the first button at the transmitter of the radio remote as long as
you want fog to be produced (see manual „Radio remote").
5. Operating the Viper 2.6
13