Quick Set Mode; Quick Set Mode Reference Guide; Quick Set Mode Operation - Ambient Weather WS-1075 User Manual

Wind Units. Press the SET
alternate the display unit between km/h, mph, m/s, knots, and bft (or Beaufort scale).
Rain Units. Press the
SET
alternate the display unit between in and mm.
The following table is a quick reference guide for the SET Mode:

8.2 Quick Set Mode

8.2.1 Quick Set Mode Reference Guide

The following table is a quick reference guide for the QUICK SET Mode. See the next section for
detailed settings.
Command
[SET] Enter Quick Set Mode, Outdoor
Temperature vs Dew Point
[SET] Relative Pressure vs Absolute
Pressure
[SET] Wind Speed Average vs Wind
Speed Gust
[SET] Rain Increments of Measure
Total Rain Reset (since reset)

8.2.2 Quick Set Mode Operation

While in the Normal mode, press the
be exited at any time by either pressing the
take effect. You can skip over any setting by pressing the
Holding the key
+ (increase) or MIN/MAX key (decrease)
rapidly.
Outdoor Temperature, Wind Chill and Dew Point Display. The outdoor temperature will begin
flashing. Press the + key to alternate the display between the outdoor temperature, wind chill and dew
point.
Version 1.1 ©Copyright 2012, Ambient LLC. All Rights Reserved.
8.1.2.5 Set Wind Units
key to set the wind units. The wind will begin flashing. Press the + key to
8.1.2.6 Set Rain Units
key to set the rain units. The rain will begin flashing. Press the + key to
Mode
SET key to enter the Quick Set Mode. The Quick Set mode can
HISTORY
8.2.2.1 Outdoor Temperature, Wind chill and Dew
Point Display
Settings
Press [+] to toggle between outdoor
temperature and dew point.
Press [+] to toggle between relative pressure and
absolute pressure.
Press [+] to toggle between wind speed average
and wind speed gust.
Press [+] to toggle between hourly rain, 24 hour
rain, weekly rain, monthly rain and total rain.
With the total rain selected and flashing in the
previous step, press [SET] + 3 seconds to reset
rain to 0.00.
key or waiting for the 10-second time-out to
key again.
SET
when in the Set mode will change values
Page 17