Initial Display Console Set Up; Radio Controlled Clock (Rcc) - Ambient Weather WS-1075 User Manual

6.4.2 Initial Display Console Set Up

1. Place the sensor array 5 to 10 feet from the display console. It is best to perform this
operation prior to installing the sensor array.
2. Make sure the sensor array is already powered up and the transmitter light is flashing once
every 48 seconds.
3. Insert 3 x AA batteries into the battery compartment on the back of the display. After
inserting the batteries into the console, all of the LCD segments will light up for a few
seconds to verify all segments are operating properly.
4. The console will instantly display indoor temperature, humidity, barometer, tendency, date
and time. The wind speed, rain, and outdoor temperature and humidity will update on the
display within a few minutes. DO NOT TOUCH ANY BUTTONS until the outside
transmitter report in, otherwise the outdoor sensor search mode will be terminated. The sensor
search icon will be present:
5. When the outdoor transmitter data has been received, the console will attempt to receive the
Radio Controlled Clock (RCC) signal.
If the outdoor sensors do not update, please reference the troubleshooting guide in Section 12.

6.4.3 Radio Controlled Clock (RCC)

After the sensor array is received by the console, the sensor will transmit weather data for 30 seconds,
and then the sensor will begin radio controlled clock (RCC) reception. During the RCC time reception
Version 1.1 ©Copyright 2012, Ambient LLC. All Rights Reserved.
Figure 8
Page 11