Table of Contents
Advertisement
8. Close the battery door. Make sure the gasket (around the
battery compartment) is properly seated in its trace prior to closing
the door. Tighten the set screw.
2.4 Display Console Set Up
1. Move the remote thermo-hygrometer(s) about 1.5m to 3m away
from the display console (if the sensor is too close, it may not be
received by the display console). If you have more than one
thermo-hygrometer, make sure they are all powered up and
transmitting on different channels.
2. Remove the battery door on the back of the display, as shown in
Figure 4. Insert four AAA (alkaline or lithium, avoid rechargeable)
batteries in the back of the display console
All of the LCD segments will light up for a few seconds to verify all
segments are operating properly.
3. Replace the battery door, and fold out the desk stand and place the
console in the upright position.
The console will instantly display indoor temperature and humidity
as designated by the
will update on the display within a few minutes on the appropriate
channel.
Figure 4
icon. The remote temperature and humidity
-5-
Advertisement
Table of Contents
