Initial Display Console Set Up - Ambient Weather WS-1090 User Manual

3.4.1 Initial Display Console Set Up

Note: The sensor array must be powered and updating before powering up the console, or the
console will give up searching for the sensors. Perform this step last.
Make certain the weather station sensor array is at least 10' away from the console and within 300' of
the console. If the weather station is too close or two far away, it will not receive a proper signal.
Insert three AA batteries into the battery compartment on the back of the display. After inserting the
batteries into the console, all of the LCD segments will light up for a few seconds to verify all
segments are operating properly.
The unit will instantly display indoor temperature, humidity, barometer, tendency, date and time.
The wind speed, wind direction, rain, and outdoor temperature and humidity will update on the
display within a few minutes. Do not touch the LCD until the outside transmitter report in, otherwise
the outdoor sensor search mode will be terminated. When the outdoor transmitter data has been
received, the console will automatically switch to the normal mode from which all further settings can
be performed.
If it does not update, please reference the troubleshooting guide in Section 9.
Note: When making an adjustment to a parameter, touch the flashing +, ON/OFF or – symbols in
Version 1.1
Figure 8
©Copyright 2010, Ambient LLC. All Rights Reserved. Page 10