Unit Identifier Switch; Vga - Supermicro X10SDV User Manual

Unit Identifier Switch

A Unit Identifier (UID) Switch and two LED
indicators are located on the motherboard. The
UID Switch is located next to the VGA port on
the back plane. The Rear UID LED (LED7) is
located next to the UID Switch. The Front Panel
UID LED is located at Pin 7 of the Front Control
Panel at JF1. Connect a cable to Pin 7 on JF1
for Front Panel UID LED indication. When you
press the UID switch, both Rear UID LED and
Front Panel UID LED Indicators will be turned
on. Press the UID switch again to turn off both
LED Indicators. These UID Indicators provide
easy identification of a system unit that may be
in need of service.
Note: UID can also be triggered via
IPMI on the motherboard. For more
information on IPMI, please refer to
the IPMI User's Guide posted on our
website at http://www.supermicro.
com.

VGA

A VGA port is located next to the LAN ports on
the I/O back panel. Use this port to connect to
a compatible VGA display.
A
B D
A
C
VGA
SRW2
JNVI2C1
LAN3/4
LED8
C
SRW1
BMC
AST2400
C
SLOT7
LEDM1
PCI-E 3.0 X16
A J21
Intel
D-1500
USB 4/5
LED3
A C JF1 I-SGPIO2
JPME1
JPL1
i350
USB 0/1(3.0)
LAN1/2
X10SDV-F
REV: 2.00
DESIGNED IN USA
BT1
JBT1
J6
FAN2
I-SGPIO1
JF1:
PWR OH HDD PWR
RST X NIC2 NIC1
ON FF LED LED
2-13
IPMI_LAN
FP PWR LED
HDD LED
COM1
NIC1 Activity LED
NIC2 Activity LED
USB 2/3
OH/Fan Fail/PWR Fail
JPI2C1
(Power Fail LED on PCB 2.00) X
PJ1
JPW1
FAN1
Chapter 2: Installation
UID Switch
Pin# Definition
1 Ground
2 Ground
3 Button In
4 Button In
UID LED
Status
Color/State Status
Blue: On Unit Identified
A. UID Switch
B. Rear UID LED
C. Front UID LED
D. VGA
16 15
3.3 V
3.3V Stby
3.3V Stby
3.3V Stby
UID LED
3.3V
Reset
Reset Button
Ground
Power Button
Ground PWR
2 1
C