Installing The Optional Transport Wheels; Installing The Grass Basket - Toro 04042 Operator's Manual

6
Installing the Optional
Transport Wheels
Parts needed for this procedure:
Transport wheels (Optional Transport Wheel Kit,
2
Model 04123)
Procedure
1. Push the kick stand down with your foot and pull up
on the handle support until the kick stand has rotated
forward, over center (Figure 15).
1
Figure 15
1. Kickstand
2. Press the wheel locking clip toward the center of the
wheel and slide the wheel onto the hex shaft (Figure
16).
Figure 16
1. Locking clip

Installing the Grass Basket

Parts needed for this procedure:
Procedure
G017244
Important: If you ever drop the basket, examine the
pitch arm contact points near the lower lip of the basket
for damage (Figure 18). Straighten them before using
the basket. Using the basket with bent pitch arm contact
points could damage the reel.
16
3. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is secured
in the groove on the axle shaft.
4. Repeat the procedure on the opposite side of the
machine.
5. Inflate the tires to 83-103 kPa (12-15 psi).
6. Carefully lower the machine off of the kickstand.
7
1
Grass basket
1. Grasp the basket by the handle (Figure 17).
1
Figure 17
1. Basket hooks
2. Guide the basket lip between the cutting unit side
plates and over the front roller (Figure 17).
3. Install the basket hooks over the frame loop (Figure
17).
G017245